So I finally got back to this project, and those instructions were helpful thanks.

Couple other notes for anyone else doing this:
The light control pod (middle of the center trim), is just clipped in place. Use a pry tool on the front (and possibly the rear if needed) and it will pop out.
The center trim will then just pop off, but it takes a bit of force (I was worried I was going to break it). Aside from the plastic clips indicated, it also clips onto the pillar trim pieces. It's easier if you use a pry tool from under the lip to separate those pieces first. I didn't on one side and sent a couple metal clips flying when it suddenly popped free (they re-attach).

 

Forget what I previously said.
You need to take the sun visors off both sides.

Then lever out and remove this cover and unscrew the mount. See above

Then the centre section trim - see above

Them the A Pillar trim